Ford GT Custom Component

Front Structural component for Ford GT Super Car!

When it comes to the most demanding requirements, Palcam can deliver!

Following component was produced from 3,000 lbs of aircraft aluminum billet, and finish machined to approximately 80 lbs. Specific features across the component maintain dimensional tolerance requirements as tight as 0.0005"

Description

 

Additive Manufacturing Initiative

Palcam Technologies Ltd. - Launches an additive manufacturing initiative focused on the development of tooling components for the High Pressure Aluminum Die Casting sector leading to efficiency gains in manufacturing resulting from reductions in cycle time, energy inputs, and tooling cost. These advancements will also expand capacities of the die cast process itself, leading to increased aluminum content per vehicle resulting in lighter more efficient vehicles.

read moreAdditive Manufacturing Initiative